Home / Tile Floors / black and white bathroom floor tile designs / White Tile Bathroom Master Shower With Black And Floor Designs Kitchen Tiles Brisbane Decor Patterned Wall Bath Grey Cheap Tiled Showers Pictures Checkered Lino Rubber
wwxl Tile Floors August 10th, 2018 - 09:49:04
In residential settings. the most common substrates [surfaces to be tiled] for flooring are wood and cement. In this article we`ll deal with deal with wood subfloors. In new construction. it`s often possible to see the structure of the subfloor and joists and usually communicate with the carpenters who built them or the contractor in charge of the project if there are any questions. In remodeling. however. sometimes one can only guess who installed the floor and how strong it is. Maybe it`s as strong as a battleship. or maybe it`s about to fall through to the basement. If a property owner is trying to install the floor himself. he or she may wonder how to know if the subfloor is strong enough. Let`s start with the technical and then translate it to the everyday way to tell.
First. you have porcelain tiles. These tiles are made by firing at high temperatures. They are also very dense and moisture resistant. You can purchase porcelain in a variety of shades and colors. Porcelain tiles are the most expensive though but with them you have tile flooring ideas that can mimic stone and other materials.
Is there an unfinished ceiling below to look up and measure the distance between joists and the condition of the wood below and how long the unsupported span is? A few minutes in the basement with a flashlight and tape measure can let you know if you have a winner (thick and deep joists. spaced closely together. in good condition. with a narrow span). or a loser (thin and shallow joists. irregularly spaced or spaced far apart. in bad condition. with a long span).
How thick is the subfloor and what is it made of? In new construction. ¾ inch plywood or Oriented Strand Board is a standard subfloor over joists that are 16 inches on center apart. We find that is almost never enough to meet the deflection standards in most homes. Other times there is old plank flooring beneath a layer of plywood. This is a wild card. since the engineering tables usually don`t include the value for planks in their calculation. but common sense says it does add some stiffness.